Wocha bin doin on your MG this week then?

Cleaned it,drove it and enjoyed it.

Removed the ecu to package up.
All ready to send to KMaps. :yesnod:

Drove 300 miles to collect a TF 160 engine and subframe.

G0RSQ wrote:

I love that look Peter.

Took the tf for a run out to market drayton...had carvery in a quaint old pub....and then.a country run to eccleshall on to stafford...where i nipped in and ........
Had front and rear tracking done.printout on left taken on 3rd may...print out on right taken today

Nice top down run out to Saundersfoot yesterday

David Aiketgate wrote: Removed the ecu to package up.
All ready to send to KMaps. :yesnod:

Got the ecu back and refitted to the engine bay. OMG, did I have a battle to get the connectors back onto the ecu! Finally achieved it and started the car up. Tickover at 2500revs. Reset the IACV using the standard method and tried again.
Much better...ticking over at 875.
So I took the car out for a quick test drive...

Honestly, :yesnod: it feels like a different car, much more responsive and...woohoo!

David Aiketgate wrote:

David Aiketgate wrote: Removed the ecu to package up.
All ready to send to KMaps. :yesnod:

Got the ecu back and refitted to the engine bay. OMG, did I have a battle to get the connectors back onto the ecu! Finally achieved it and started the car up. Tickover at 2500revs. Reset the IACV using the standard method and tried again.
Much better...ticking over at 875.
So I took the car out for a quick test drive...

Honestly, :yesnod: it feels like a different car, much more responsive and...woohoo!

I want one! :yesnod:

Problem is I don't have MEMS3 :nonod:

cairnsys wrote:
I want one! :yesnod:

Problem is I don't have MEMS3 :nonod:

One of the reasons I am swapping from a 143 to a 160

My little baby is being operated on. :dry:

Two new lower front wishbones, some new brake pipe and, hopefully, an MOT tomorrow. :hugs:

Best of luck for the MOT David.