VVC head with Cams and timing pullies

If anyone has a VVC head the e3cam shafts and timing pullies, I am in the market.

Must be in a servicable state.

Many thanks.

As a replacement for a damaged head?

The head is ok and in good condition. When the engine was rebuilt the guy fail to fit the pulley correctly and the bolt hole become elongated and fractured the both that holds the pulley to the end of the camshaft. So it is probably better to get the three cam shaft rather that just replace the exhaust camshaft and pulley,

I have the 3 cams and pulleys if you want them

I no longer need them as my VVC head as been ported nd polished and converted to non VVC

Many thanks for the offer, what price do you want for them?

And where are you located?

Many thanks.

I think it might be cheaper to just get a replacement exhaust camshaft and associated pulleys, VVC camshafts go for an arm and a leg each.

The exhaust camshaft shares its profile with quite a few models you might find in a scrapyard.
From direct experience if the VVC mechs are timed up properly and it works then leave well alone, nearly went mad trying to put mine back together, I could have done with 2 spare hands and an extra pair of eyes to get everything in place at the same time.

Your decision, it would be a good experience to tinker with the VVC unit if you want to.

Seal wrote: Many thanks for the offer, what price do you want for them?

And where are you located?

Many thanks.

Click on location under the avatar.

You need to set yours though, you're in Ohio!:lol:
Glovebox at the top, on left 'set your location'

David,

May be that I am missing something but am unable to get any response when following your insturctions to change my location?

Many thanks.

Are you getting the map when you click on set your location?

You could try going to members map under the community tab above and then drag and drop the little man to where you are in the world.

Seal wrote: Many thanks for the offer, what price do you want for them?

And where are you located?

Many thanks.

£55 posted

2 xVVC cams shafts
1 x Exhaust cam
4 x pullies

All from standard TF 160 engine

Allan

I'm in Swindon, Wiltshire

:omg: vvc inlet camshafts x2 rover k series 1.8vvc Completed